ST-Link(ST 정품)

1. 제품명

ST-Link(ST 정품)



2. 제품소개
ST-Link는 ST Microelectronics의 STM8 and STM32microcontroller families의 모든 제품에 사용 가능한
in-circuit debugger and programmer 입니다. JTAG/SWD인터페이스를 이용해서 STM8 and STM32에
플래시 Write와 디버깅을 할 수 있습니다.

제품 구매 : http://www.toolparts.co.kr

3. 제품특징
* 5 V power supplied by USB connector.
* USB 2.0 full speed interface compatible.
* USB standard A to Mini-B cable provided.
* SWIM specific features:
  1.65 V to 5.5 V application voltage supported on SWIM interface.
  SWIM low speed and high speed modes supported.
  SWIM programming speed rate:
* 9.7 Kbytes/s in low speed,
* 12.8 Kbytes/s in high speed.
  SWIM cable for connection to an application with an ERNI standard connector
  vertical (ref: 284697 or 214017) or horizontal (ref: 214012).
  SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector.
* JTAG/SWD specific features:
  3 V to 3.6 V application voltage supported on JTAG/SWD interface and 5Vtolerant inputs.
  JTAG/SWD cable provided for connection to a standard JTAG 20-pin pitch2.54 mm connector.
* Direct firmware update feature supported (DFU).
* Status LED which blinks during communication with PC.
* Operating temperature 0 to 50 °C.
* JTAG cable connection

Pin No	Name	ST-LINK Funciton	Target connection
1	TVCC	Target VCC	MCU VCC
2
3	TRST	GROUND	GND
4	UART-RX	Unused	GND or not connected
5	TDI	JTAG TDI	TDO
6	UART-TX	Unused	GND or not connected
7	TMS	JTAG TMS, SW IO	TMS, SWIO
8	BOOT0	Unused	GND or not connected
9	TCK	JTAG TCK, SW CLK	TCK, SWCLK
10	SWIM	Unused	GND or not connected
11	NC	not connected	not connected
12	GND	GROUND	GND
13	TDO	JTAG TDO	TDI
14	SWIM-RST	Unused	GND
15	RESET	RESET	RESET (optional)
16	KEY	not existing pin	not connected
17	NC	not connected	not connected
18	GND	GROUND	GND
19	VDD	VDD (3.3V)	not connected
20	GND	GROUND	GND

4. 지원하는 디버그 소프트웨어
(1) KEIL MDK, IAR Workbench

5. 메뉴얼
ST-Link 사용자 메뉴얼

6. 제품 구성
(1) ST-Link 1Ea
(2) USB Cable 1Ea
(3) SWIM separate-wires cable 1Ea
(4) USB Driver/Software, CD